I reset my Cisco 2911 ISR to factory defaults now I can't access....
Hi everybody - I reset my Cisco 2911 ISR to the factory defaults. I then used the configuration guide to do the initial set-up through the CLI. I was able to assign IPs to the GE0/0 and GE0/1 ports. Now I cannot access the GUI device manager at all. I was able to ping the IP of GE0/0 so I know the adapter took the IP assignment, but still no GUI access. Can anyone help me with this issue? I have spent hours trying to restore it, with no luck.
Any help at all is greatly appreciated. Thanks in advance.
I reset my Cisco 2911 ISR to factory defaults now I can't access
Hi Reza - Thanks for the help, I really appreciate it.
I followed the link you provided, and I see that the page it goes to is in the Unified Communication section of the Cisco website. Does this apply to a router that isn't doing anything other than basic Layer 3 routing?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.