i turned on jumbo frame on my 3750/2960/asa-5515x. The interfaces are on 9000 after I reload but my 3750/2960 is still on "system mtu routing 1500".
Do I need to put it also on jumbo frame? What will be the behaviour on old system like XP (with NIC that doesn't support 9000), old printer system (like label printer), wireless (with B type), etc. I need jumbo frame primarily on my vpshere 5.0 system and ip hp-san4500.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...