Re: I would like to know that How many number next-hop support w
"How many number next-hop support when I set the PBR"
When you set the ip next-hop value in PBR, it is not restricted to a hop count, as long as the IP address you set as the next-hop is in the routing table of the router it will be forwarded, the limitation on hop count would come from the routing protocol in use. For instance if you were running RIP, a router 16 hops away would not be in your routing table, if you set it's IP address as the next-hop, it will be unreachable.
"When I set the ip next-hop in parallel, is it possible loadbalancing per each next hop?"
No, load balancing is achieved through dynamic routing protocols, although I'm sure you could probably design an extremely complicated QoS solution to achieve this.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...