Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IBGP in Active state

Hi all,

I had two routers directly connected via Ethernet

I had configure both as in attached file

I had found that my ibgp neighbour is in active state

any suggestion ?

B#sh ip bgp summary

BGP router identifier 10.10.10.9, local AS number 200

BGP table version is 1, main routing table version 1

Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd

2.2.2.22 4 200 0 2 0 0 0 never Active

A#sh ip bgp summary

BGP router identifier 10.10.10.3, local AS number 200

BGP table version is 1, main routing table version 1

Neighbor V AS MsgRcvd MsgSent TblVer InQ OutQ Up/Down State/PfxRcd

2.2.2.21 4 200 22 22 0 0 0 never Active

4 REPLIES
New Member

Re: IBGP in Active state

SOLVED

REGARDS

Cisco Employee

Re: IBGP in Active state

Re: IBGP in Active state

I think you didn't have reachability to the loopbacks

Narayan

New Member

Re: IBGP in Active state

Thanks dear,

issue was to do clear ip bgp

thanks for a link

Regards!!

254
Views
0
Helpful
4
Replies