Which one of those command have precedence over the other one ?
Which one is better over the other one ?
With the mls rate-limit option, we have the possibility to check default parameter with : "show mls rate-limit" command is exist equivalent for : "ip ICMP rate-limit unreachable"
We have also Catalyst 3550 switches, on which we have to rate-limit genaration of ICMP unreachable message for same reason as 6509. I understand the :"ip ICMP rate-limit unreachable" command is my only option "under "mls " the only option I have is QoS or aclmerge. Under thoses parameter I have no way to rate-limit ICMP message generation....
I have check in running-configuration I did not find any reference to ICMP rate-limit command, I hope this is active like explain in document http://www.cisco.com/warp/public/707/cisco-sn-20030125-worm.shtml, ACL for IOS section, (Version 12.2(44)SE3) but I would like to be able to confirm if any show command exist to confirm this.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...