Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IDSM-2 with VSS system

Hi,

We are looking forward to install a Cisco 6513 with IDSM-2 in each chassis in a VSS mode. Does anyone have an experience with the configuration of the 6513 ?  Also, lets assume I installed one active IDSM in each chassis with identical configuration... what happens when one of them fails ?

Appreciate your Support.

3 REPLIES
VIP Super Bronze

Re: IDSM-2 with VSS system

Hi Amro,

You would need to have one IDSM-2 in each chassis, because when the active VSS device fails the entire box will fail.

refer to this paper for more info on how to deploy IDSM in VSS:

http://www.cisco.com/en/US/products/ps9336/products_tech_note09186a0080a7c72b.shtml#idsm

HTH

Reza

Community Member

Re: IDSM-2 with VSS system

Thank you Raza..

I have read the document. But what I am interested in is how the configuration would look like in case of Promescouse mode ot inline mode.

Regards,

Amro

Community Member

IDSM-2 with VSS system

Amro,

Did you ever get any  information about this?  I am also planning on implementing VSS with each chassis having an IDSM module.  Haven't figured out how to best deploy it (with configurations)

Thank you, Brian

958
Views
0
Helpful
3
Replies
CreatePlease to create content