Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IE 3000

We purchased around 20 IE 3000 switches. Out of 20 we opened 8 boxes and only 3 are working. all others cannot boo from the flash. If we are giving dir command its not showing the flash

3 REPLIES
Silver

Re: IE 3000

I think it is not possible for all switch but may defect any one. When you first set up the switch, you should use Express Setup to enter the initial IP information. Doing this enables the switch to connect to local routers and the Internet. You can then access the switch through the IP address for additional configuration.

Cisco Employee

Re: IE 3000

Try these commands assuming that you are at switch: prompt.

flash_init

load_helper

dir flash:

New Member

Re: IE 3000

Just remove the flash card on the switch outer body and push it inside again.. Power on the switch,,,

169
Views
0
Helpful
3
Replies