Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IE3000 Uplink Port

Good Afternoon,

I have an IE3000-8tc-e (layer 3 capabilities), with uplink port issues.  The connection actually works, but it won't let me set it to "duplex full" and "speed 100."  The other end is set to full duplex, speed 100.

 

Here's the config for the port:

interface GigabitEthernet1/2
 description LAN-UPLINK to #### int Fa0/24
 no switchport
 ip address 10.x.x.x 255.255.255.xxx
 ip access-group outbound in
 ip helper-address 10.x.x.x
 ip pim sparse-dense-mode
end

the IOS is: ies-ipservices-mz.122-55.SE5

 

I keep getting the commands not recognized error.

Would I have to shut the port down before issuing the commands, then enable the port after getting them in there?

 

Thank you in Advance.

6 REPLIES

Hey,As this switch supports

Hey,

As this switch supports both copper and SFP fiber ports, so if you are using SFP, it will allow you to change speed and duplex depending upon SFP used, check the link:

http://www.cisco.com/c/en/us/td/docs/switches/lan/cisco_ie3000/software/release/12-2_55_se/configuration/guide/scg_ie3000/swint.html#wp1028308

HTH.

Regards,

RS.

New Member

Thank you for the prompt

Thank you for the prompt reply RS.

 

I need to use the copper port for the uplink.

New Member

interface GigabitEthernet1/1

interface GigabitEthernet1/1
 description Ethernet Connection
 media-type rj45
 speed 10
 duplex auto
 

New Member

Having the same on our IE3000

Having the same on our IE3000's.  We have recently upgraded the IOS to the latest ies..... version and it appears to have broken the GIG ports.

We have a couple of devices plugged into the uplinks (which do not support GIG and only support 10/100 half and full duplex and we need to set them for 10/FULL and cannot get the switch to take those commands.

Is there a current BUG ID or a workaround known ?

Thanks

~J

 

New Member

has there been a way to set

has there been a way to set this? I have the same problem as well.

New Member

interface GigabitEthernet1/1

interface GigabitEthernet1/1
 description Ethernet Connection
 media-type rj45
 speed 10
 duplex auto

 

67
Views
0
Helpful
6
Replies
CreatePlease login to create content