Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

inability to read x6816 gbic

have a 6509 that is unable to read this gbic module. shows as being powered down.

I am running in hybrid mode and attached a show module text file.

8 REPLIES

Re: inability to read x6816 gbic

can you provide " show sys " and " show environment power ", it could be the card is not getting enough power from the switch power supplies.

New Member

Re: inability to read x6816 gbic

here you go as requested..

New Member

Re: inability to read x6816 gbic

I thought that this was posted but did not..

Re: inability to read x6816 gbic

you only have one power supply, I suspect the WS-CAC-2500W PS is not enough to power the additional blade you're installing, I could be wrong. For the sake of test, if blade 7 is not used, I would slightly pull blade from slot 7, and re-insert the 6148A in slot 6 to see if it comes online.

New Member

Re: inability to read x6816 gbic

I pulled all blades out excluding the SFM2 and the X6516 but it was still unreadable. I had a 6548 and 6148a in the chassis simultaneously and they both ran fine. Also, I have only one PS in another 6500 chassis that houses several blades including two x6516 with no problem.

Re: inability to read x6816 gbic

did you try instlling the 6148a in the other 6500 chassis? if the blade don't come up in the other 6500 then you may have a faulty card.

New Member

Re: inability to read x6816 gbic

it works fine even in the 6509 chassis when I boot up from the linear flash card that has the code for the 6513 chassis.

New Member

Re: inability to read x6816 gbic

Is the WS-X6816-GBIC even supported under CatOS?

147
Views
0
Helpful
8
Replies