Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inbound and outbound QoS rate limit for internet traffic

Hi,

I have been trying to configure a policy which limits a specific VLAN or subnet to X amount of bandwidth however i am having issues with the inbound and outbound working on a single device.

For example we have two subnets.

VLAN 101 (10.10.10.0/24) and VLAN 102 (11.11.11.0/24), VLAN 101 is to have 5mbps with 1 mbps burst and VLAN 102 is to have 15mbps and 3 mbps burst.

I run into the issue where the QoS policy does not apply in both directions.

A brief topology is below:

Customer site ------> Customer firewall (FWSM) ---------------> 7606 ---------------------> ASR1000

       LAN                      VLAN101 (10.10.10.2)              10.10.10.1     default route---> (intenet router)

                                                                             (VLAN interface)

We would ideally like to do all QoS on the ASR if possible.

Regards,

Scott

Everyone's tags (3)
1336
Views
0
Helpful
0
Replies
CreatePlease to create content