Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Incorrect bandwidth displays on port channel interface

Hello All,

I have a bit strange situation. Port channel interface has only 1 member, G1/0/3, but the bandwidth displays 2 Gbit. In addition, if I add one more member interface, the bandwidth becomes 3 Gbit. Does anyone have any ideas? What has happened there?

#sh int port-channel 12

Port-channel12 is up, line protocol is up (connected)

Hardware is EtherChannel, address is 001d.70b9.2383 (bia 001d.70b9.2383)

Description: <<<< SA >>>>

MTU 1500 bytes, BW 2000000 Kbit, DLY 10 usec,

reliability 255/255, txload 1/255, rxload 1/255

Encapsulation ARPA, loopback not set

Full-duplex, 1000Mb/s, link type is auto, media type is unknown

Media-type configured as connector

input flow-control is off, output flow-control is unsupported

Members in this channel: Gi1/0/3

ARP type: ARPA, ARP Timeout 04:00:00

Last input 00:01:54, output 00:00:00, output hang never

Last clearing of "show interface" counters never

Thanks,

Nitass

2 REPLIES
Purple

Re: Incorrect bandwidth displays on port channel interface

Probably a cosmetic anomaly (read bug) with the IOS . Also check channel with the show etherchannel summary and make sure it only sees one interface in the channel .

New Member

Re: Incorrect bandwidth displays on port channel interface

Actually, there are 5 port channel interfaces but only one interface has this problem. The others seem to be Ok.

Regarding the IOS, it is running 12.2(35)SE5.

Thanks,

Nitass

286
Views
0
Helpful
2
Replies
CreatePlease login to create content