line con 0
line 1 5
transport input telnet
I need to delete line 1 5, but I get an error message (Vty line 1 doesn't exist). Apparently, because of this bogus entry, I cannot create line vty 0 4. Is there any way to delete this entry without making a copy and re-configuring the whole switch?
Yes - that is the problem. This is the way the switch was configured when I got here. I know I could set the switch to original configuration and re-program it, I was just trying to avoid that. But there doesn't seem to be any way to delete the bad lines.
We are pleased to announce availability of Beta software for 16.6.3. 16.6.3 will be the second rebuild on the 16.6 release train targeted towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are looking for early feedback from custome...