I have two C2960S stacked switches. Does anybody know if there's a way to increase the maximum number of Etherchannels? The max number is 6 but i need around 9-10. Is there any way? (Some licence or something?)
I'm not aware of any way to increase that number because it's based on the platform used. If you need more then the supported six channels on the 2960S you need a newer/bigger switch. The 2960-X supports up to 24 channels, the 3850 up to 128 (based on the config-guide).
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...