I am looking for a minimal baseline switch configuration to use setting up a set of switches.
The process now is to reset the switch to factory defaults, assign an ip address with switch/telnet password. Then telnet to the switch and manually enter commands to set up ssh/scp. Secure copy a baseline switch configuration file to startup-config. Finally, secure shell login to the switch and copy startup-config running-config. This is repeated for a chain of about a dozen switches.
Is there a simpler solution? What is a minimal set of startup-config entries?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.