Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Inject default route(s) into EIGRP for Internet access

I have a core 6500 sup II switch that is connected to 2 default gateway paths Metro and MPLS . 0.0.0.0 0.0.0.0 X.X.X.X is directly connected over Metro Ethernet. When that connection goes down I want the default gateway to adjust to network #2 0.0.0.0 0.0.0.0 H.H.H.H 10. what is the best practice for this? I put in a weight statement and pulled the default X.X.X.X connection but the H.H.H.H did not pick up.. Any thoughts on this?

1 REPLY
New Member

Re: Inject default route(s) into EIGRP for Internet access

Make sure the x.x.x.x is an ip address and not an interface. When you do a show ip route, do you see the floating static default route in your routing table? If you want to send this down stream, you need to redistribute this static route.

126
Views
0
Helpful
1
Replies