Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

input errors on 6509

Hi,

I have a problem with input errors on a WS-X6148-RJ-21, on a port where a server (fujitsu-siemens S100) is connected in teaming we see 2 input errors/15minutes. We changed already the server, also the port/mod and i took another cable, we disconnected also the secundary nic but the problem stay the same. I connected the server with only the primary nic to a catalyst 2950 and there we see no problems.

What is the next step ? I didn't find any known issue.

In att you can see the port statistics/mod/sw-ver

Thanks,

Peter

3 REPLIES
Cisco Employee

Re: input errors on 6509

Have you tried hard coding the speed/duplex on the ports. Input errors are caused by bad NIC/Cable., speed/duplex issues. Try upgrading the NIC drivers on the servers. Also if possible try upgrading the IOS on the switches as well.

-amit singh

New Member

Re: input errors on 6509

Hi,

The speed/duplex are hard coded on 100FD, other cables are already used also the server HW was changed. Leave us the drivers and the IOS. But the same hardware was connected to a 2950 and no errors.

Thanks,

Peter

New Member

Re: input errors on 6509

We did an update of nic drivers and the teaming driver but still the same problem, so it should be the IOS ?

Peter

190
Views
0
Helpful
3
Replies