Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

input errors only on 4500

I am getting only input errors? What can cause this? I am using nic load balancing across two 4500's could this be an issue?

Here is an example output of sh int

0 runts, 0 giants, 0 throttles

263 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored

0 input packets with dribble condition detected

  • LAN Switching and Routing
2 REPLIES
Silver

Re: input errors only on 4500

Make sure proper settings ( trunk and mode ) enabled between the 4500 switches.

Use Ethernet Configuring and Troubleshooting Ethernet 10/100/1000Mb Half/Full Duplex Auto-Negotiation

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml

New Member

Re: input errors only on 4500

how would that affect the switchport a host is plugged into? The trunk port does not have errors on it, ONLY the host ports.

903
Views
0
Helpful
2
Replies