Hi,
Input and output packet are not showing in VLAN 41 of Cisco WS-C4510R-E (MPC8548)Switch, IOS cat4500e-entservicesk9-mz.122-52.SG.bin. However the nodes connected via VLAN 41 are able to communicate with others nodes in VLAN 41. Below is the VLAN status. Attached is the Tech-Support.
Fourth_Flr_User_Switch#sh int vlan 41
Vlan41 is up, line protocol is up
Hardware is Ethernet SVI, address is 0025.8466.427f (bia 0025.8466.427f)
Internet address is 172.20.41.3/24
MTU 1500 bytes, BW 1000000 Kbit, DLY 10 usec,
reliability 255/255, txload 1/255, rxload 1/255
Encapsulation ARPA, loopback not set
Keepalive not supported
ARP type: ARPA, ARP Timeout 04:00:00
Last input 00:00:00, output never, output hang never
Last clearing of "show interface" counters 01:09:59
Input queue: 0/75/0/0 (size/max/drops/flushes); Total output drops: 0
Queueing strategy: fifo
Output queue: 0/40 (size/max)
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
L3 in Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
L3 out Switched: ucast: 0 pkt, 0 bytes - mcast: 0 pkt, 0 bytes
0 packets input, 0 bytes, 0 no buffer
Received 0 broadcasts (1334 IP multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
340 packets output, 15942 bytes, 0 underruns
0 output errors, 0 interface resets
0 output buffer failures, 0 output buffers swapped out
Fourth_Flr_User_Switch#
