Installation time of NPE-G2= 7200 serie...

Cisco Support Community

Community Member

‎02-02-2012 12:49 PM

Hi,

Can anybody give me a rough idea of what the installation time for the Network Processor engine is:

NPE-G2=

7200 series NPE-G2 engine with 3 GE/FE/E ports

Do you reckon it can be done in two hours?

Any help is much appreciated!

Labels:

LAN Switching and Routing

1 REPLY

VIP Super Bronze

‎02-02-2012 02:48 PM

The hardware installation should not take more then an hour. You also need about 2 to 3 hours to move the config over from the old to the new one, test it and make sure connectivity is there. So 4 hours should be enough for all of it.

Please remember to tag your threads and help support "Teachers without Borders"

https://supportforums.cisco.com/community/netpro/idea-center/communityhelpingcommunity

HTH

Latest Documents

Cisco ESW-520-24P Switch Configuration

Created by Kevin DeMott on 04-19-2018 01:49 PM

We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des... view more

BGP Conditional Advertisement Feature

Created by Dennis Mink on 03-06-2018 09:17 PM

This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does "Th... view more

le router cisco 887 VA-K9 ne diffuse pas les adresses IP au reseau local

Created by mustiman on 03-05-2018 05:53 AM

Question bonjours j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m... view more