Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Installing a Netflow Service Card for a Supervisor V

Is there any installation procedure to install a Netflow Service Card (WS-F4531=) on a Supervisor V (WS-X4516)?

I can only find a procedure to do it for a Supervisor IV, but i am not sure if this procedure is valid for a Supervisor V.

Regards

Pedro

1 REPLY
Cisco Employee

Re: Installing a Netflow Service Card for a Supervisor V

Hi,

There should be no difference between SUP IV and SUP V for installation procedure.

Hardware and Software Requirements

To install and use the NetFlow Services Card, you need the following:

Catalyst 4500 series switch (Catalyst 4503, 4506, 4507R, or Catalyst 4006)

Supervisor Engine IV or Supervisor Engine V running Cisco IOS Version 12.1(13)EW or greater

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78-15214.html#wp59422

IOS CONFIG GUIDE

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/20ew/configuration/guide/nfswitch.html

KK.

362
Views
0
Helpful
1
Replies