08-31-2010 01:51 PM - edited 03-06-2019 12:45 PM
Is there any installation procedure to install a Netflow Service Card (WS-F4531=) on a Supervisor V (WS-X4516)?
I can only find a procedure to do it for a Supervisor IV, but i am not sure if this procedure is valid for a Supervisor V.
Regards
Pedro
08-31-2010 06:48 PM
Hi,
There should be no difference between SUP IV and SUP V for installation procedure.
To install and use the NetFlow Services Card, you need the following:
•Catalyst 4500 series switch (Catalyst 4503, 4506, 4507R, or Catalyst 4006)
•Supervisor Engine IV or Supervisor Engine V running Cisco IOS Version 12.1(13)EW or greater
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/hardware/configuration/notes/78-15214.html#wp59422
IOS CONFIG GUIDE
http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/20ew/configuration/guide/nfswitch.html
KK.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: