Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Installing DSP from 2600 series into 2600xm series

Hi,

I have a doubt and I don't know if this possible.

Can I install a DSP (PVDM) from a 2600 series router into a 2600xm series router?

Regards

7 REPLIES
Hall of Fame Super Silver

Re: Installing DSP from 2600 series into 2600xm series

Hello Antonio,

you have a PVDM or PVDM2?

two different generations of DSPs exist for cisco routers so your question is wise.

Hope to help

Giuseppe

Re: Installing DSP from 2600 series into 2600xm series

Thank you for your response Giussepe.

Sincerenly, I don't know exactly how can I discover what type of PVDM I have?

Regards

New Member

Re: Installing DSP from 2600 series into 2600xm series

'sh voice dsp'

Check out DSP TYPE in the output.

Re: Installing DSP from 2600 series into 2600xm series

Hi,

I've already known it, but my problem is that the original router has crashed and I cannot execute this command.

If I connect this DSP, is there any risk?

Regards

New Member

Re: Installing DSP from 2600 series into 2600xm series

I highly doubt you'll "fry" anything. If I were you I'd just try and see. Do you see any writing on the PVDM's at all?

Re: Installing DSP from 2600 series into 2600xm series

When you tell "fry anything", what is anything?

PVDM?

Router?

Regards

New Member

Re: Installing DSP from 2600 series into 2600xm series

Don't take my word for it but I doubt you'll ruin the router or the PVDM. Why don't you compare models on the DSP Calculator? http://www.cisco.com/cgi-bin/Support/DSP/cisco_configure.pl

You can plug in both of your router types and go from there.

413
Views
0
Helpful
7
Replies