Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Installing inmage on Cat 4510 IOS SupV.

I am in the process of upgrading the image on a Cat 4510 IOS.

When I do a show bootvar it shows the following

BOOT variable = not available

CONFIG_FILE variable not available

Configuration register is 0x2101

ignore-config: disabled

auto-config: non-recurring

console baud: 9600

I have entered the following:

# boot system flash c45....bin;c45....bin

# conf reg 0x2102

but when I do a show bootvar, it still shows the same as above.

I am wary of rebooting this now as I do not know if it will pick up the new download?

In addition do I write

boot system flash device:c4500.bin

or

boot system flash c4500.bin

Please help.

Thanks

3 REPLIES
Purple

Re: Installing inmage on Cat 4510 IOS SupV.

The statement would be boot system flash bootflash: . You must do a write mem before the boot statement will show up in the "show bootvar" statement.

New Member

Re: Installing inmage on Cat 4510 IOS SupV.

Thanks. Will let you know how i get on.

New Member

Re: Installing inmage on Cat 4510 IOS SupV.

Thanks Glen

It also shows

BOOTLDR = not set

even though on the Show version, there is a boot image.

Should I also isuse a bootldr statement or leave it as blank?

386
Views
0
Helpful
3
Replies