Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Intel Pro 100 & Cisco Catalyst 2960G

Hello, I have this issue:

Switch Cisco Catalyst 2960G + utp cat 6 cable + nic Intel Pro 100 VM (With WIN XP latest drivers)

I can't get it work.

Autosensing in both points = cable disconected

100 full in both points = connection ok, but no pings

100 half in both pints = connection ok, but no pings

10 full or half in both points = lose many pings (50% of them)

This problem happens only with this type of nic (tested three different ones). If I change the nic (intel pro 1000, 3com, or realteck, or Broadcom) the connection is ok at any speed (10 / 100 / 1000).

Is there any know bug or problem related with this nic?

NOTE: unchecking "allow the computer turn off this device" doesn't work.

Thanks

1 REPLY
Cisco Employee

Re: Intel Pro 100 & Cisco Catalyst 2960G

Hello,

Issue seems to be with the Intel drivers.

http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note0918

6a00800a7af0.shtml#nic_comp

I would suggest you contacting Intel and see if they have a fix for the

drivers.

Regards,

NT

564
Views
0
Helpful
1
Replies
CreatePlease login to create content