Whenever hosts in one VLAN need to communicate with hosts in another VLAN, the traffic must be routed between them. This is known as inter-VLAN routing. On Catalyst switches it is accomplished by creating Layer 3 interfaces (Switch virtual interfaces (SVI) ).
To have a communication between 2 vlans in a layer 2 switch The ip default-gateway command is used to specify the default gateway when routing is not enabled. But the layer 2 switch should be connected to a layer 3 device which will be doing routing on behalf of this device.
Dude if you can explain your requirement in detail probably I can help
If you do not want ip routing to be enabled than there is a workaround for that and what you can do is configure another 2 interface again with vlan 2 and vlan 3 and connect those two interface with a cross cable and your machines in 2 different vlan can communicate then.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.