Inter vlan routing with Catalyst 4507

[jahurkmans]

Anyone have any pointers on configuring inter vlan routing on Catalyst 4507 switches

[glen.grant]

   Not sure what you are looking for , here is the complete configuration guide, 

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sg/configuration/guide/confg_gd.html

[nkarpysh · Accepted solution]

Hi,

You may want to check L3 interfaces page in the document Glen mentioned above and specifically "logical Layer 3 VLAN Interfaces":

http://www.cisco.com/en/US/docs/switches/lan/catalyst4500/12.2/31sg/configuration/guide/l3_int.html#wp1029667

That explains how L3 VLAN interface is working to provide following:

The logical Layer 3 VLAN interfaces provide logical routing interfaces to VLANs on Layer 2 switches. A traditional network requires a physical interface from a router to a switch to perform inter-VLAN routing. The Catalyst 4500 series switch supports inter-VLAN routing by integrating the routing and bridging functions on a single Catalyst 4500 series switch.

And there few configuration examples as well.

Please advise if that it is what you were looking for.

Nik

[jahurkmans]

Thanks, that's what I needed.

[jahurkmans]

Thanks, that’s what I needed.

[nkarpysh · Accepted solution]

Hi John,

You can close this thread pining the right answers for it to be useful in future.

Nik