Hi Guys and Girls, I am sitting here in the early hours of the night in Ireland trying to figure out if it possible to complete my simulator network. this is the low down
1 network lots of clients; but all in different VLANs. I have clients in VLAN 120 and clients in VLAN 30 both connected to the same switch and more clients in VLAN 120 and 30 connected to another switch and even more clients in VLAN 120 and 30 connected to another switch... the 3 switches are connected to a L3 switch and a dhcp server is connected to the L3 switch, how do i get intervlan routing working or am I over thinking this big time... I am up very late
I want a DHCP pool that will assign IP addresses to all subnets; I know I will need more than 1 pool for this.
I don't know where to configure this....on another router...on the L3 switch.... do I need to set up multiple DHCP servers if not; and I set up multiple DHCP pools on say 1 router then how do I bind that pool to a particular VLAN...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.