Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Inter VLAN Routing

See attachment thanks

trying to get trunking with vlans and intervlan working with packet tracer

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Inter VLAN Routing

See attachment thanks

trying to get trunking with vlans and intervlan working with packet tracer


Hi,

If Fa0/1 is configured with sub interface with dot1q id belongs to specific vlans PC in that vlan will be using default gateway of that interface of router subinterface, so with sub interface configured physical interface are not configured with ip address subinterface act as logical interface for that particular segment.

PC which does not belongs to any vlan that is native vlan will be part of vlan1 which should be allowed in trunk with sub interface configured for dot1q id 1 with native specified,so that user in native vlan can communicate with other vlans.

Hope to Help !!

Ganesh.H

2 REPLIES
VIP Super Bronze

Re: Inter VLAN Routing

PC-2 has to be in a vlan and as you said it is part vlan 1.  So, you still need to configure the default gateway for the PC on the sub-interface of the router.  vlan 1 is just like any other vlan.

HTH

Reza

Re: Inter VLAN Routing

See attachment thanks

trying to get trunking with vlans and intervlan working with packet tracer


Hi,

If Fa0/1 is configured with sub interface with dot1q id belongs to specific vlans PC in that vlan will be using default gateway of that interface of router subinterface, so with sub interface configured physical interface are not configured with ip address subinterface act as logical interface for that particular segment.

PC which does not belongs to any vlan that is native vlan will be part of vlan1 which should be allowed in trunk with sub interface configured for dot1q id 1 with native specified,so that user in native vlan can communicate with other vlans.

Hope to Help !!

Ganesh.H

181
Views
9
Helpful
2
Replies