cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
235
Views
0
Helpful
1
Replies

Inter vlan

networking11
Level 1
Level 1

hi all,

i have 3 blocks of l1-L2 switches, in which first block contains 2 switches of configured 2 vlans vlan 1 in sw11, vlan 1&2 in sw10 of which fast ethernet ports are trunked between Sw10-Sw11 and gigaports of Sw11 and Sw10 are given to L3switch.

in the 2Nd block of L2 switches-3(Sw9 toSw7) is given the vlan 3 and connected to L3Switch via Giga and inturn the 3 switches are cascade or truncated.

in the 3rd block of L2 switches-6(Sw6 toSw1) is given the vlan 2 and connected to L3Switch via Giga and inturn the 6 switches are cascade or truncated.

give me the config

1 Reply 1

subharojdahal
Level 1
Level 1

Hi

Your question seems abstract. Well, if you just want to have inter-vlan routing among those 3 vlans than you have and just to have config, then you could follow the following commands.

interface vlan 1

ip address X.X.X.X X.X.X.X

no shut

interface vlan 2

ip address X.X.X.X X.X.X.X

no shut

interface vlan 3

ip address X.X.X.X X.X.X.X

no shut

If you want to configure HSRP then you should have few more command to configure.

HTH

subharose

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: