The configuration on L3-6509 is sub interface with encapsulation dot1q and IP address 192.168.0.1/24. Circuit between Nortel 1850 to Nortel 1800 is based on L2 link (TDI). Client IP address is 192.168.0.2/24. Ping from client PC to L3-6509 didn't work. If I replace the L3-6509 with Cisco 2600 or L3-4908, both with sub interface and encapsulation dot1q, ping from client PC is working. I think the problem is with L3-6509 IOS.
IOS version for L3-6509 is s72033-advipservicesk9_wan-mz.122-18.SXF5.bin.
IOS version for L3-4908 is cat2948g-in-mz.120-14.W5.20.bin
IOS version for 2600 Router is c2600-is-mz.122-4.T1.bin
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...