Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Interface and Reset

Hi,

I have a Catalyst 4003, I have been trying to interface into the WS-X4232-L3 module to access the fast ethernet ports to shutdown some of them. However, I cannot figure out the interface for them?

Secondly, the switch is secondhand. Someone left a password on the Supervisor Engine and I can't acces it. I tried looking for a recovery password so I can make a few changes, but I haven't been able to find anything specifically. It is a WS-X4012.

1 REPLY
Hall of Fame Super Gold
477
Views
0
Helpful
1
Replies
CreatePlease to create content