Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
266
Views
0
Helpful
1
Replies

interface configs

s.crawford
Level 1
Level 1

‎12-05-2006 09:30 AM - edited ‎03-05-2019 01:11 PM

why do some routers show "config-int" when you enter interface configuration mode, while others show "config-if"?

Labels:
0 Helpful
1 Reply 1

amit-singh
Level 8
Level 8

‎12-05-2006 10:12 AM

Hi Friend,

I think its only a command that's in the designed IOS. May its designed diffrently in some older IOS and that's why it shows you config-int. In any new IOS I havenot seen this command. Is that on a new IOS or an older one. Can you paste the IOS version details?

HTH,

-amit singh

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card