Have you checked the physical interfaces, too? Usually, errors in interfaces are due to bad cables, misconfiguration or bad speed/duplex negotiation or failed NICs. In the swith as well as in the machine/s connected to it.
See if there is a physical int which belongs to that vlan and is having problems. Clear counters, shutdown the int and verify counters in the vlan again many times to see if they increases. Bring the int up again and see what happens. If the counters increase, try to change the cable, check again, if everything keeps the same, change to another port in the switch. If nothig fixes up, maybe the NIC in the host is broken -> change it. If nothing works, well, I don't know what is happening :)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...