Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Interface range command authorization failing

I am currently using TACACS ver 4.0. I wanted to restrict access to certain commands on my switches, ws3560 and 3750 series.

When I add this additional command to enable the restriction.

aaa authorization config-commands

i.e. int range g 0/1- 24

I get a command authorization failed

If I configure a fewer amount of ports

say ports 1-5.

The int range command will pass.

Has anyone else had this problem before.

Thanks

2 REPLIES
Community Member

Re: Interface range command authorization failing

I am experiencing the very same problem.

IOSs:

c2960-lanbase-mz.122-25.SEE3.bin

c3550-i9q3l2-mz.121-14.EA1a.bin

Did you find a solution?

Regards,

AL

Community Member

Re: Interface range command authorization failing

We really haven't found a solution. We are just doing a few ports at a time, for now.

Thanks for your inquiry.

162
Views
0
Helpful
2
Replies
CreatePlease to create content