Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interface Vlan configuration

I have just assigned a new interface vlan:

interface Vlan208

ip address 192.168.208.18 255.255.255.240

But the problem is when I do

sh ip route 192.168.208.16

I get

% Network not in table

What is the problem?

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Interface Vlan configuration

Hi,

1.Check whether vlan interface is Up.Use command "show interface vlan 208"

2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"

HTH..rate if helpful..

2 REPLIES

Re: Interface Vlan configuration

Hi,

1.Check whether vlan interface is Up.Use command "show interface vlan 208"

2.If it is not up, see whether any port is added into vlan 208? If it is not , kindly add a port to vlan 208 and then see "show ip route"

HTH..rate if helpful..

New Member

Re: Interface Vlan configuration

Oh, right..

I was too drunk yesterday ))

Thank you, my friend

179
Views
0
Helpful
2
Replies