Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Interfaces on standby Supervisor Engine IV

Hi

On a Cisco 4507 with Redundant Supervisor Engine IV. Can the Interfaces/GBIC on the standby Supervisor be used or can you only use interfaces on the current active supervisor. I cant find any documentation on this.

Regards

Kev

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Interfaces on standby Supervisor Engine IV

The first module on both Supervisor engine would be active. The second module on both Supervisor engines will not be accesible.

This document should help you http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a0080134f18.shtml#topic2

HTH

Hoogen

Do rate if i have helped :)

2 REPLIES
Silver

Re: Interfaces on standby Supervisor Engine IV

The first module on both Supervisor engine would be active. The second module on both Supervisor engines will not be accesible.

This document should help you http://www.cisco.com/en/US/products/hw/switches/ps663/products_tech_note09186a0080134f18.shtml#topic2

HTH

Hoogen

Do rate if i have helped :)

New Member

Re: Interfaces on standby Supervisor Engine IV

Cheers for that its just what I was looking for

113
Views
5
Helpful
2
Replies
CreatePlease login to create content