It is good to understand the rate at which drops are occuring. Unless theres CRC on the link, drops are too less in rate.What is the output of sh int fa0/21. Buffer size can be increased with hold-queue command on the interface.
Hello, output drops in your case as compared to the interface output is less than .1%. I dnt think this should be bothering, at such a low rate. Is there any impact on access to applications. are they observing any slowness or latency. Otherwise this is ok.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...