Sorry, I not sure whether this is the correct place to post this question.
I have a server S1 and a load balancer connected to a CISCO switch and a server S2 connected to the load balancer.
The problem is when I tried to telnet from S1 to S2 phyiscal IP address and port, sometimes telnet can be established sometimes it can't. Why is so? There is no configuration on load balancer. I was trying to bypass the load balancer. The error I got is TCP/IP 10054.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...