Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

internet Internet protocol processing disabled

i have a serial interface that will not come up and it gives me this error msg "Internet protocol processing disabled" it is WIC 2T smart serial back to back connection..the connection is from one 2611xm to another 2611xm router smart serial. i want to use it for my ccna lab..any idea ?

3 REPLIES
Hall of Fame Super Bronze

Re: internet Internet protocol processing disabled

Did you assign an IP to that interface ?

You mentioned you have a back-to-back serial connection, did you configure clocking on the DCE end ?

New Member

Re: internet Internet protocol processing disabled

first i used encapsulation type hdlc, then config clocking on the inter..it won't come up, i reconfig the int with ip add and then ecapsulation type ppp..config clocking on dce end , did no shutdown..it won't still come up..everything is down down...do u think it is the cable ?...

Hall of Fame Super Bronze

Re: internet Internet protocol processing disabled

The down/down issue may be cable related but I'm concerned about the original message "Internet protocol processing disabled".

Are you still experiencing the message after entering an IP on the interface ?

Can you post the router's config along with the show version output ?

12548
Views
0
Helpful
3
Replies