Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

intervlan and wireless bridge as a medium between router and switch

hi to all

I was doing intervlan routing ,,, i used 2600 router and 2900 series

i create two vlan... vlan 2 and vlan 3

on router i create three subinterfaces.. .

interface 0/0.1 for vlan 1 ip address

interface 0/0.2 for vlan 2 ip address

interface 0/0.3 for vlan 3 ip address 192.1683.1

with proper encapsultation

i used a straight cable to join switch and router.. and create a trunk port in switch

every thing is working fine pcs from vlan 2 can ping pcs from vlan 3

then i put the twist

and instead of straight through cable i used a pair of wireless bridges of brand powerstation

now each vlan can ping its gateway and others gateway too

but cannot ping pcs in other vlan....

now i dont whats the problem

so i came for help from the experts... plz kindly help me out...this is basically RnD not a job task


Everyone's tags (3)