cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
938
Views
0
Helpful
17
Replies

intervlan routing 3560g

zaikini_23
Level 1
Level 1

Hi all!

I have 3560g with EMI. I connect my PC to GEth0/3 3560g and create SVI with address x.x.x.209 255.255.255.240, on my PC address is x.x.x.210 255.255.255.240. I add Linksys SRW224G4 to GEth0/2 port 3560g. I have trunk between 3560g and Linksys. Linksys has management vlan 553 and 10.0.77.70/27 address in this vlan. I create SVI (vlan 553) on 3560g with address 10.0.77.65 255.255.255.224. Linksys has default-gateway 10.0.77.65.

3560G:

...

!

ip routing

...

!

interface Vlan201

ip address x.x.x.209 255.255.255.240

...

!

interface Vlan553

ip address 10.0.77.65 255.255.255.224

#sh ip route | i 10.0.77

C 10.0.77.64/27 is directly connected, Vlan553

#sh ip route | i x.x.x

x.x.x.0/28 is subnetted, 1 subnets

C x.x.x.208 is directly connected, Vlan201

I can ping 10.0.77.65 from my PC and I can ping x.x.x.209 from Linksys, but I can't ping 10.0.77.70 (Linksys) from my PC and I can't ping x.x.x.210 (PC) from Linksys.

I enable debug ip icmp packet, when I ping Linksys from PC or I ping PC from Linksys I'm not see anything. When I ping 10.0.77.65 from PC I see rows with echo requests and echo replies. I see is similar for Linksys.

What is problem may be?

17 Replies 17

Great !

yes, thanks.

I'm disturb because I want using linksys with trunk to catalyst..

Why would you need a trunk if you are only carrying a single Vlan over this link ?

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco