we have office in differrent loaction people from those office wants to connect to our server using local address through intarnet presently they have access through public ip how do i configure my router to let them access my server through private ip insted of public ip
I assume ur server is having IP in privavte range & is getting natted on the FW or router itself.
Heres what u hv to do:
If ur remote offices are connected to central site where the server is located via point-to-point links, then u may prefer to run routing protocol on all routers to advertise the private range of subnets. These subnets will be recvd by synchronised among all routers. Once these routes are recvd by remote end routers, users there can access your server by its original IP.
You may then remove the nat on Firewall or router. If there is firewall in between the user & server, the u may add acl for the server access.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...