Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Invliad boot configuration string on slave

Hi All,

The Cat6513 with 2 Supervisor engine 720, has an issue with boot string configuration, Please refer the following output. (show dianostic sanity)

6513-01#show diagnostic sanity

Pinging default gateway 192.168.30.1

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echos to 192.168.30.1, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/4 ms

Invalid boot image "sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin" specified in the boot string on the slave.

Please check your boot string on the slave.

None of the images specified in the boot string on the slave are valid.

Please specify at least one valid image in the slave boot string to ensure the

slave is in a bootable state.

How do i configure the boot image for the salve?

Redundancy mode : SSO

6513-01#dir /all

Directory of sup-bootflash:/

1 -rw- 42827268 Jan 14 2008 17:02:55 -05:00 s72033-ipservicesk9-mz.122-18.SXF11.bin

6513-01#show boot

BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable =

Configuration register is 0x2102

Standby is up

Standby has 458720K/65536K bytes of memory.

Standby BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

Standby CONFIG_FILE variable does not exist

Standby BOOTLDR variable =

Standby Configuration register is 0x2102

Thank you!

2 REPLIES
Hall of Fame Super Gold

Re: Invliad boot configuration string on slave

Can you do a "show boot"?

New Member

Re: Invliad boot configuration string on slave

Hi,

6513-01#show boot

BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

CONFIG_FILE variable does not exist

BOOTLDR variable =

Configuration register is 0x2102

Standby is up

Standby has 458720K/65536K bytes of memory.

Standby BOOT variable = sup-bootflash:s72033-ipservicesk9-mz.122-18.SXF11.bin,1;

Standby CONFIG_FILE variable does not exist

Standby BOOTLDR variable =

Standby Configuration register is 0x2102

Thank you!

245
Views
0
Helpful
2
Replies