Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IOS and config erased

Need to find a way to load IOS in a 2801 router. I have username and password, but I am unable to download the Xmodem software...

5 REPLIES

Re: IOS and config erased

You mean the 2801 router currently has no IOS?

Use Xmodem, its available in TeraTermPro and Microsoft Windows HyperTerminal. You just need the rollover (or console) cable.

However, for 2801 router you can still download the IOS image using TFTP from the ROMMON. Check this link http://www.cisco.com/en/US/products/hw/routers/ps259/products_tech_note09186a008015bf9e.shtml

New Member

Re: IOS and config erased

I can only go in ROMMON mode, and it shows no dir files and won't take any commands to set up IP addresses to do the IOS load

Re: IOS and config erased

Check my first reply again, I just add a link :)

New Member

Re: IOS and config erased

http://www.cisco.com/warp/public/130/xmodem_generic.pdf

Actually had a bad Compact flash card. New card and tried this procedure. Thanks

New Member

Re: IOS and config erased

If you are using Windows use Hyperterminal

228
Views
5
Helpful
5
Replies
CreatePlease to create content