I have a 3825 router running 12.4-11.XJ4. I want do bridge a vlan through it, config below. but it is not passing the traffic. I have a router connected each side of the bridge router one on each port g0/0.25 and g0/1.25. I just want to create a L2 link between R1 and R2. I can however see the MAC address of the opposite router in the ARP tables and if I leave it pinging about 1 in 1000 pings gets through.
R1 <--vlan25--> Bridge Router<--vlan25--> R2
interface GigabitEthernet0/0 no ip address duplex auto speed auto media-type rj45 no keepalive ! interface GigabitEthernet0/0.25 encapsulation dot1Q 25 bridge-group 25 ! interface GigabitEthernet0/1 no ip address duplex auto speed auto media-type rj45 no keepalive ! interface GigabitEthernet0/1.25 encapsulation dot1Q 25 bridge-group 25
bridge 25 protocol ieee
I have a 2nd 3825 with came s/w abd same config (just different vlan IDs) and it works fine.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.