Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

IOS Collect Command

What version of IOS code must be running on WS-C3750G-48PS-E/WS-C3550-48-EMI in order to view the TOP TALKERS on ports? The SH TOP command in CATOS is very helpful and I am looking for a similar command but only in IOS. Most of the installed switches are at rev level 12.2(25)SEB4. Thanks in advance!

4 REPLIES

Re: IOS Collect Command

I don't think this is supported in CAT3750/3550 since "toptalkers" should be calculated on Netflow data.

Community Member

Re: IOS Collect Command

I recall on another post that it was a 2 step process.

collect top 10 counters int all

sh top counters int report

I am just not sure what rev level of IOS code you must for the command to work.

Netflow data ? Can you explain. tnx!!

Hall of Fame Super Gold

Re: IOS Collect Command

I don't think you can find this on the 3750. However, as a substitute, try using the following commands:

sh interface counters

sh controllers utilization

Does this help?

Re: IOS Collect Command

Toptalker will need netflow feature. But 3750/3550 does not support netflow feature. That's why you don't have "toptalker" on 3750/3550

162
Views
5
Helpful
4
Replies
CreatePlease to create content