Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS upgrade on Cisco 2960

Hello,

I have uploaded a new firmware on my Cisco 2960 switch and reloaded the config, but it is still using c2960-lanbasek9-mz.122-44.SE6 and not c2960-lanbasek9-mz.122-55.SE.bin

Here is my flash

Directory of flash:/

    2  -rwx     9771439   Mar 1 1993 23:21:00 +00:00  c2960-lanbasek9-mz.122-55.SE.bin

    3  -rwx        4858   Mar 1 1993 18:54:41 +00:00  config.text

    4  -rwx        1914   Mar 1 1993 18:54:41 +00:00  private-config.text

    5  drwx         512   Mar 1 1993 00:09:18 +00:00  c2960-lanbasek9-mz.122-44.SE6

  547  -rwx        3096   Mar 1 1993 23:34:25 +00:00  multiple-fs

27998208 bytes total (7390208 bytes free)

Can I set the IOS to boot from or should I just delete the old IOS?

Thanks

3 REPLIES
New Member

Re: IOS upgrade on Cisco 2960

Delete the one that you do not want to use, then it will load the one you want to

use

Purple

Re: IOS upgrade on Cisco 2960

  Probably the config register is set to just load the first one it finds in flash.  If you want to have 2 images in flash then you would have to change that to 0x2102 and then add a boot statement pointing to the new image .  A show version will show you the config register setting.

New Member

Re: IOS upgrade on Cisco 2960

Andy,

You can keep both images and set the IOS you want switch to boot. If you issue 'Show boot', you should see current settings. Later use

config t

boot system flash:

commands to set the IOS you want the switch to boot from.

-AJ.

1086
Views
0
Helpful
3
Replies
CreatePlease login to create content