10-28-2010 08:42 AM - edited 03-06-2019 01:46 PM
Hello,
I have uploaded a new firmware on my Cisco 2960 switch and reloaded the config, but it is still using c2960-lanbasek9-mz.122-44.SE6 and not c2960-lanbasek9-mz.122-55.SE.bin
Here is my flash
Directory of flash:/
2 -rwx 9771439 Mar 1 1993 23:21:00 +00:00 c2960-lanbasek9-mz.122-55.SE.bin
3 -rwx 4858 Mar 1 1993 18:54:41 +00:00 config.text
4 -rwx 1914 Mar 1 1993 18:54:41 +00:00 private-config.text
5 drwx 512 Mar 1 1993 00:09:18 +00:00 c2960-lanbasek9-mz.122-44.SE6
547 -rwx 3096 Mar 1 1993 23:34:25 +00:00 multiple-fs
27998208 bytes total (7390208 bytes free)
10-28-2010 08:45 AM
Delete the one that you do not want to use, then it will load the one you want to
use
10-28-2010 08:51 AM
Probably the config register is set to just load the first one it finds in flash. If you want to have 2 images in flash then you would have to change that to 0x2102 and then add a boot statement pointing to the new image . A show version will show you the config register setting.
10-28-2010 09:26 AM
Andy,
You can keep both images and set the IOS you want switch to boot. If you issue 'Show boot', you should see current settings. Later use
config t
boot system flash:
commands to set the IOS you want the switch to boot from.
-AJ.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: