Not sure of the question here . It's as simple as checking to see if there is enough space in flash for your new image, do a "dir flash: " . Is the reported free space bigger than the image size you are trying to put on ? If no then you will have to delete at least 1 image to make room for the new image.Then issue "copy tftp flash: " , it will ask you your address of the tftpserver , input , it will then ask you the name of the image just copy and paste the name of the image in there and hit enter a couple of times and it should go if there is enough space in flash which verified with the "dir flash: command. The image name you posted is not a valid imagename , check the imagename and try to download the valid imagename again.
Your question is not very clear but if you are asking whether it is OK to delete the old IOS from the FLASH and download a new one, then yes - this is OK. I would still recommend backing up the old IOS just in case you will need to revert back.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...