Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IOS version for 4506

I need to update the IOS on my 4506. Its currently running 122-20.EWA4.bin I see a couple of files out there but I want to make sure I get the right one, what file should I be getting for this switch?

4 REPLIES
Purple

Re: IOS version for 4506

Dpends on what feature set you currently have in the switch.

New Member

Re: IOS version for 4506

this is the full bootflash im running now.

cat4000-i9k91s-mz.122-20.EWA4.bin

How do I get the features listed so I can post it here?

New Member

Re: IOS version for 4506

You currently have the BASIC L3 3DES feature set.

So if you wanted to go to 12.2.25 you would get the file cat4000-i9k91s-mz.122-25.EWA14.bin to maintain your current feature set.

If you want to go to a newer IOS than that you should probably mention whether you use ssh to access the switch or not. Most of the newer IOS decisions can be whittled down a lot just by deciding if you need ssh access and how much mem you have.

In addition to letting the group know whether you use ssh or not you should also include a "show ver" and "show idprom all" output. Knowing what sup versions you have will help a lot to determining what IOS versions your system can support.

New Member

Re: IOS version for 4506

Im being told I should go with

Cat4500-ipbasek9-mz.122-50.SG1.bin

to be fully up to date. However I want to make sure I'm being told to the correct file.

I have attached the output from those commands

357
Views
0
Helpful
4
Replies
CreatePlease to create content